Trimitsis Woodworking Weblog
  • About
  • Contact
  • Travels with Musti

Posts by milton

History versus gravity

Posted on 23 November 2010

We’ve recently started work on the temporary stabilization of a lovely 1840 Greek Revival carriage house near Boston, MA.  When I was first asked to look at the project over the summer, the building was substantially out of plumb.  When we started work last week, the condition of the building was becoming alarming.   The building had been leaning considerably to the right; now it had pitched over further, and seemed to be tipping backwards as well.  We set up a plumb line as a reference mark to allay our fears that it was moving further by the hour.   Among the carriage house’s many woes, the floor framing system, sill, and foundation had all failed on the right and rear sides of the building. …

Categories: Structural work, Uncategorized

Tagged: carriage house, footings, structural work

0 Comments

+Read more

The walnut saga

Posted on 18 November 2010

We recently finished a renovation in Brookline, MA, in a generally worker-friendly building:  there was air conditioning and heat at the appropriate times, and, since we were working in a penthouse unit, an excellent view.  The building had only one dammit feature, which will become relevant later in the story. The architect we worked with, Carol Marsh of Helios Design Group, did her job perfectly:  she designed a beautiful space, and left the details of execution to us.  Perhaps the most challenging detail of the kitchen was a ten-foot-long walnut counter, supported at one end by cabinets and at the other end by a single leg. The fun started early, as it turned out that stock of sufficient length was not common.  Highland Hardwoods…

Categories: Uncategorized

Tagged: Brookline, screw-ups, stairs, steel, table, walnut

0 Comments

+Read more

Rotational symmetry

Posted on 3 November 2010

After years of threatening to do so, we’ve finally launched ourselves beyond the realm of planar symmetries.  We found a lovely old Powermatic #90 lathe (born in 1971) that we purchased from a machine dealer (and upstanding fellow, by all appearances) named Mike Savoie.

Powermatic Model 90 lathe

 

Evan, who helped to catalyze the purchase, put our newest chunk of cast iron through its first paces .

Man turning spindle on Powermatic lathe

 

Evan turning 2
Categories: Shop work

Tagged: lathe, Powermatic 90, shop, turning, woodworking

0 Comments

   Newer entries »

Trimitsis Woodworking

  • Please visit us

Categories

  • Annals of Forensic Carpentry
  • Architectural photography
  • Before and after
  • Building science
  • Details
  • Dorchester
  • entomology
  • Found
  • History
  • Seen
  • Shop work
  • Structural work
  • trade secrets
  • Uncategorized
  • victorian
  • vintage

Return to top

© Copyright 2014